Use a level and plumb to check the placement of the stringers. Attach the stringers to the deck using angle brackets and 3” galvanized deck screws. Cut a 2x6 board to fit snugly between the two stringers at their base. This will be used to fasten the stairs to the concrete pad.
Measure down from the top of the deck and mark the top of your stair stringers with a level. For example, if each stair will be 6 3/8" finished height, we will measure down 7 3/8" to compensate for the missing stair tread.
Simple math and accurate cuts yield a perfect set of deck stairs Episode 8: Installing Skirtboards and Decking Learn the process for handling and attaching this dense exotic hardwood decking
I am looking to install privacy screens on my concrete patio. I just want to put up two 6x6 posts with Titan Wood Post Anchors, either 35 or 70 apart, Read More. Are Sleeve Anchors (expansion bots) Overkill? Jun 17, 18 09:33 AM. I see the recommendation to secure the Titan Wood Post Anchors into concrete is concrete screws like tapcon or GRK.
Shopping list for How to Safely Attach a Deck to a House: - 2x4s and 2x6s½-inch x 10-inch galvanized lag screws with washers - ½-inch x 10-inch masonry wedge anchors
The space between the concrete and the decking material is essential because it allows for air circulation and water drainage to occur, thus protecting the capped composite deck boards from the risk of excessive moisture-related damage.
9. Attach the wood-composite decking to the top of the concrete stoop using the same masonry anchors. 10. Conceal each anchor in decking with a plug cut from a composite decking board. 11. Sweep decking clean of all debris.
Step 3 - Attach Stringers to Concrete Concrete is either the base underneath the stringer or it may also be a concrete footing that you have poured to provide extra support and strength to your stairway.
When the lower floor is made of concrete, you will need a special fastener to attach the wood to it unless one has already been embedded for this purpose. Fortunately, there are many such fasteners available that can be used in holes that you pre-drill in the concrete.
How much room do you have above the concrete deck surface? Usually its about 7". If you use 4X4 joists and 5/4 decking, the deck surface would be about 3" below the door sill. Is this acceptable? What would the size of the finished deck be? You will need to research info about deck support spans etc.
Composite decking is a low-maintenance alternative to traditional wood decking. Composite decking is composed of a mixture of wood and plastic and offers the look of wood without the high maintenance involved with wood planks. Using composite decking on a concrete foundation requires a frame for attachment.
Veteran carpenter Mike Guertin explains the loads and codes applying to deck-stair connections. He provides a simple and stout detail for attaching the stairs to the deck using readily available metal framing hardware. Guertin also explains how he pours a concrete stair landing pad and how he attaches the bottom of the stairs to that.
To cut the beams to the right length, start by setting the end of a straight joist against the house at the edge of the deck layout. Square it by marking the house 6 feet from the deck corner and marking the joist 8 feet from the corner. Adjust the joist until the diagonal between the marks measures 10 feet. Mark and cut the beams.
Attaching wood railing to concrete porch I want to add a wood railing to my concrete porch for safety. The porch has 4 brick pillars that the railings need to attach to; they are 7', 6' & 7' apart and the last leg of the porch is 4' 6" and goes from last brick pillar to the cedar siding of the house.
This video will provide you with a few ways to attach your stair stringers to either a concrete floor or a wood framed subfloor and deck. For more information about stair building, visit our ...
Below is a step by step instruction on how to properly connect the stair stringers to concrete. Step 1 - Understand Stringers and Stairway Construction The stringers must be constructed so that they are strong enough to support the heavy weight of people walking up and down the stair treads.
To attach a wood handrail post to concrete: Mark the location of the holes in a metal post bracket on the concrete. Drill holes in the concrete of the right diameter for lead shields using a masonry bit in a hammer drill.
Attaching a wooden railing to a concrete porch adds a touch of elegance. Many people are choosing wooden railings over iron because wood does not rust and it's easy to remove or replace. It's an easy project that you should be able to finish in less than a day.