Experiments by the Gougeon brothers, the famous marketers of their own brand of epoxy, revealed that epoxy can be applied over wood treated with ethylene glycol with no bonding issues. If you do decide to use antifreeze …
Somewhere I remember reading antifreeze can preserve wood in structural parts of the deck. I have glassed in blocks of ash, drilled for the stanchions.
This helps to preserve the wood by preventing fungal growth, and facilitates the drying process. In addition, ethanol will replace all the water in the wood, which will avoid the problem of collapse and checking: Ethanol should be replaced at least 3 times over the next 2 weeks.
You can also treat wood with Borax though, a less commonly known way to cure wood with high water content, inhibit fire, and keep wood rotting insects away. Borax is a water soluble mineral that you can treat a number of products, including for use in the building industries.
Armor All Wood Preservative Brochure Armor All Wood Preservatives Information Sheet Clear Coat Wood Preservative is a clear paintable solution that provides protection against rot and mildew on above ground exterior lumber such as fences, decks, sashes, doors and outdoor furniture.
Anti Freeze wood rot treatment discolouration? by Dave (Ireland) I am writing in reference to my wife Ann Marie's boat Helios, featured on this site. After reading the section on wood rot and its treatment, the recommendation is to use ethylene glocol used in antifreeze or borate solution.
If you use a soft bristle paint brush I have found that 1 litre of cold pressedLinseed Oil will cover an area approximately 3-4 times greater than that of 1 litre of the best store bought wood preservative..... so you are already well into money saving mode! And as it is an air drying natural oil, you get a really good looking finish.
I agree that some wood as a standoff between wire and tree will likely protect the tree in many ways, including probably reducing goat damage to the bark. "the qualities of these bacteria, like the heat of the sun, electricity, or the qualities of metals, are part of the storehouse of knowledge of all men.
There are many ways to preserve fall leaves, from pressing to waxing to drying. Preserving with glycerin is unique, however, because it keeps the leaves supple and soft and preserves quite a bit of the color.
In these next four pages I'm going to explain the process I used to save a couple pieces of wood that were key pieces to the floor restoration part of my Rickenbacker. These pieces of wood, which you'll see on the next page, had the common old wood problems. Some dry rot, and a bug problem.
Ethylene Glycol as a wood preservative. Discussion in 'Fiberglass and Composite Boat Building' started by Trevlyns, Jun 6, 2007.
Copper II Wood Preservative is a green paintable solution that provides protection against rot and mildew on above ground exterior lumber such as sashes, doors, millwork, fences, windows and plywood. It is formulated for projects where a “soft green” finish matching typical pressure treated lumber colour and no after-coat of paint is desired.
Using propylene glycol as a do it yourself wood preservative so you don't have to buy harshly treated lumber. You don't want to use pressure treated wood for garden squares due to the chemicals used to treat the wood.
Re: Ethylene glycol (auto antifreeze) treated wood safey Propylene Glycol as a vehicle to carry boric acid works well. The boric acid is commonly available under various names as ant, roach, flea and mold killer.
Sap and heart wood dry differently and very quickly on thin cuts of wood. As soon as you get your piece home put it in a round container (may have to be a 50-gallon drum cut way down on the sides.) Thin cover the entire piece of wood with denatured alcohol (costs about $15.29 per gallon at the box stores).
If the wood is kiln dried, the heat will kill any PPB, so borax is not needed. Second, if applied to dried wood, the borax is in a water solution and if applied to dried wood, will not penetrate very far into the wood, yet the PPB will often be quite deep. Wetting a dried wood like oak can increase the risk of serious checking and honeycomb.
Posted By: woodgeezer on 01/03/13 02:49pm PEG is a common process for woodturners to stabilize wood and "replace" the moisture within the cells. That said,it is not done with anti-freeze,but a rather costly proprietary compound.
How to Preserve Wood Cross Cuts and Keep Them from Splitting or Cracking Hardware Tips from Tiff. ... is antifreeze a good wood preservative - Duration: 7:30. Robb's Homemade Life 1,250 views.